Browsing by Author "Pereira, E."
Now showing 1 - 9 of 9
Results Per Page
Sort Options
- Electrical AC behaviour of MPCVD diamond Schottky diodesPublication . Pereira, L.; Rodrigues, A.; Gomes, Henrique L.; Pereira, E.The present work reports some experimental results on the electrical AC behaviour of metal-undoped diamond Schottky diodes fabricated with a free-standing MPCVD diamond film (5 mum thick). The metals are gold for the ohmic contact and aluminium for the rectifier. The capacitance and loss tangent vs, frequency shows that capacitance presents a relaxation maximum at frequencies near 10 kHz at room temperature. Although the simple model (small equivalent circuit) can justify the values for the relaxation, it cannot justify the departure from the Debye model, also verified in the Cole-Cole plot. Taking into account the existence of traps in the depletion region, a best fit to the experimental results was obtained. The difference between the Fermi level and the band edge of 0.2-0.3 eV is in agreement with the activation energy found from the loss tangent analysis. The capacitance with applied voltage (Mott-Schottky plots) gives a defect density of 10(16) cm(-3) with contact potentials near 0.5 V and the profile of defect density obtained shows a major density (approx. 10(17) cm(-3)) in a layer with a thickness less than 50 nm from the junction, decreasing by one order of magnitude with increasing distance. Finally a structural model is proposed to explain the AC behaviour found. (C) 2001 Elsevier Science B.V. All rights reserved.
- Electrical characterization of CVD diamond-n(+) silicon junctionsPublication . Rodrigues, A. M.; Gomes, Henrique L.; Stallinga, Peter; Pereira, L.; Pereira, E.The electrical characteristics of CVD-diamond/n(+)-Si heterojunction devices are reported. Below 250 K the diodes show an unusual inversion of their rectification properties. This behavior is attributed to an enhanced tunneling component due to interface states, which change their occupation with the applied bias. The temperature dependence of the loss tangent shows two relaxation processes with different activation energies. These processes are likely related with two parallel charge transport mechanisms, one through the diamond grain, and the other through the grain boundary. (C) 2001 Elsevier Science B.V. Ah rights reserved.
- Interface properties and capacitance-voltage behaviour of diamond devices prepared by microwave-assisted CVDPublication . Rodrigues, A. M.; Gomes, Henrique L.; Rees, J. A.; Pereira, L.; Pereira, E.Free standing diamond films were used to study the effect of diamond surface morphology and microstructure on the electrical properties of Schottky barrier diodes. By using free standing films both the rough top diamond surface and the very smooth bottom surface are available for post-metal deposition. Rectifying electrical contacts were then established either with the smooth or the rough surface. The estimate of doping density from the capacitance-voltage plots shows that the smooth surface has a lower doping density when compared with the top layers of the same film. The results also show that surface roughness does not contribute significantly to the frequency dispersion of the small signal capacitance. The electrical properties of an abrupt asymmetric n(+)(silicon)-p(diamond) junction have also been measured. The I-V curves exhibit at low temperatures a plateau near zero bias, and show inversion of rectification. Capacitance-voltage characteristics show a capacitance minimum with forward bias, which is dependent on the environment conditions. It is proposed that this anomalous effect arises from high level injection of minority carriers into the bulk.
- Microelectrical characterisation of diamond films: an attempt to understand the structural influence on electrical transport phenomenaPublication . Pereira, L.; Pereira, E.; Gomes, Henrique L.; Rodrigues, A.; Rees, A.; Cremades, A.; Piqueras, J.The properties of microelectrical conduction in microwave plasma assisted chemical vapour deposition (MPCVD) diamond films were investigated using an atomic force microscopy probe, giving a morphological map of the electrical conduction with a spatial resolution better than 500 nm. Also, a cathodoluminescence map with a spatial resolution of about 1 mu m was obtained, giving the possibility of correlating the defects involved in the different carrier transport phenomena. Using micro-Raman analysis several bands could be identified. It is found that the defects responsible for the cathodoluminescence (CL) blue band are responsible for the major part of the electrical conduction in diamond films, while the defects localised in < 111 > surfaces, responsible for the green CL emission, could be involved in a less conductive process. (C) 2000 Elsevier Science S.A. All rights reserved.
- Performance of ex situ bismuth film rotating disk electrode in trace metal analysis by stripping chronopotentiometry: definition of the depletion regime and optimization of experimental parametersPublication . Rocha, L. S.; Pereira, E.; Duarte, A. C.; Pinheiro, J. P.The potentiality of the ex situ deposited bismuth film electrode, allied to the rotation of a glassy carbon disk electrode (BiFE-RDE), was exploited in trace metal analyses of lead(II) and cadmium(II) by stripping chronopotentiometry (SCP). A single BiFE (6.2 nm film thickness) can be used for a 1-day term with no significant variation in the analytical signal. The limit of detection (3s) for a deposition time of 40 s and an oxidation current of 15 10 9 A was 1.5 10 8 M for Pb(II) and 3.0 10 8 M for Cd(II). BiFE-RDE was successfully applied to the direct SCP determination of lead(II) in a fresh water certified material.
- Photoconductivity and electrical properties of diamond films grown by MPCVDPublication . Pereira, L.; Pereira, E.; Gomes, Henrique L.The electrical and photoconductive features of as-grown microwave-plasma-assisted chemical-vapour deposition (MPCVD) diamond films are studied in correlation with magnetic results obtained from electron paramagnetic resonance (EPR). Also, the morphology is analysed by atomic force microscopy (AFM) showing [111] crystals with a good uniformity of the deposit. The photoresponse as well the current-voltage features observed show an efficient photogeneration of carriers while the optoelectronic characteristics of the metal-diamond junction have an ideality factor of 1.6 together with a rectification ratio of about 10(4) at +/-2.5 V. The nature of the mechanisms responsible for the conduction is discussed. (C) 1998 Elsevier Science S.A.
- Polycrystalline diamond thin film as wide bandgap material: the optoelectronic behaviour and the relationship with the structurePublication . Pereira, L.; Pereira, E.; Rodrigues, A. M.; Gomes, Henrique L.In this work metal - Microwave Plasma CVD diamond Schottky devices were studied. The current density vs. applied voltage reveals rectification ratios up to 10(4) at \ +/- 2V \. Under illumination an inversion and increase of the rectification is observed. The carrier density is 10(15) cm(-3) and the ideality factors near 1.5. The dark current vs. temperature shows that below 150 K the bulk transport is controlled by a hopping process with a density of defects of 10(16) cm(-3). For higher temperatures an extrinsic ionisation with activation energy of 0.3 eV takes place. The correlation with the polycrystalline nature of the samples is focused.
- Sustainable approach for recycling seafood wastes for the removal of priority hazardous substances (Hg and Cd) from waterPublication . Monteiro, Rui J. R.; Lopes, Cláudia B.; Rocha, Luciana S.; Coelho, João P.; Duarte, Armando C.; Pereira, E.Mercury and cadmium are considered by the water framework directive priority hazardous substances. In this work, the capacity of crab carapace and clam shell wastes to remove mercury and cadmium from water was evaluated under batch conditions, for realistic contamination scenarios in monometallic and binary solutions. The results evidenced that in monometallic solutions and under studied operational conditions, both biosorbents can achieve Hg2+ removal efficiencies higher than 80% and the kinetic process is well described by two of the most widely used equations, the pseudo-second order and the Elovich model. In terms of biosorption equilibrium, crab carapace and clam shell wastes displayed very distinct behaviours. While clam shells achieve the complete monolayer coverage and the isotherm is well described by the Langmuir model, crab carapace powder display a more unusual behaviour, that is well described by the BET isotherm, and is characterized by an almost convex shape to the concentration axis, with an infinite slope for an Hg2+ concentration in solution around 25 mu g/L. In binary solutions, both wastes are able to uptake simultaneously Hg2+ and Cd2+, however the uptake of Hg2+ was inhibited in some extent, attributed to the high kinetic and equilibrium selectivities of the bio-wastes for cadmium. (C) 2016 Elsevier Ltd. All rights reserved.
- UV and visible photoconductivity of undoped diamond films: morphology and related electrical transport phenomenaPublication . Pereira, L.; Pereira, E.; Gomes, Henrique L.UV and visible photoconductivity and electrical features of undoped diamond thin films grown by microwave plasma-assisted chemical vapour deposition (MP-CVD) on silicon and copper substrates are studied. The results are correlated with morphology properties analysed by atomic force microscopy (AFM) and micro-Raman. The photoconductivity presents several bands from 1.8 to 3.8 eV that are dependent on the substrate used to grow the samples in spite of some common bands observed. The J-V curve tin DC) in samples grown on Si has a rectifier behaviour (Schottky emission) in opposition to the samples grown on Cu that have no rectification (SCLC conduction). With these results we can conclude that diamond based optoelectronic devices behaviour is controlled by two kinds of structural defects localized in microcrystal and in its boundaries. A general structure model for the optoelectronic behaviour is discussed. (C) 2000 Elsevier Science S.A. All rights reserved.